Technical parameter of the Security Display Stand for Mobile Phone:
- 1.Product size: 90*50*35mm
- 2: Single weight:250g
- 3:Main material :ABS
- 4.Shell Color: pearl white
- 5.Internal Battery type: 3.7V rechargeable lithium battery.
- 6.External power adapter: DC5V 1000MA
- 7.Battery Standby Time: 50hours
- 8.Charge indicator: charging in red , full in green
- 9.Alarm sound: 105DB.
- 10.Alarm indication: LED red flashes.
How does the Security Display Stand for Mobile Phone work for security?
- 1:Three Contacts disconnection alarm.
- 2:Short Circuit Alarm Function
- 3:Remote Start and Disarm the Alarm.
- 4:Password function,Change the password freely
How does the Security Display Stand for Mobile Phone work for charging?
- 1:Phone Charging and security by one cable.
- 2: Applies for any brand mobile phone ,cable interface optional
- 3: GB/EURO/ANSI/BS power plug available.
What accessories does the Security Display Stand for Mobile Phone have?
- 1.host base (rechargeable lithium battery inside)
- 2, Aalarm sensor probe(with a magnetic back, paste 3M adhesive. Extension cords )
- 3.harger and USB charging cable
- 4, Cell phone charging adapter cable
- 5, Remote control
- 6 Operation Manual
- 7 Additional 3M adhesive and screws
How to install the Security Display Stand for Mobile Phone?
- 1.Clean the display case, then turn on switch on the bottom of Hot security cellphone /mobile phone display holder /stand with charging and alarm host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open f the screw hole cover firstly)
- 2.Connect the charger of Hot security cellphone /mobile phone display holder /stand with charging and alarm with the alarm host,the other end into the power socket in preparation for a fixed monthly charge.
- 3.Tear off the 3 adhesive tapefrom the Anti-Theft Terminal product display and paste exhibit's back fastened
- 4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the product
- 5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status
- 6.The installation is set up
Are there any other photos of the Security Display Stand for Mobile
